Before you start working on the braking system, attach a warning notice to the steering wheel to indicate that the vehicle is under repair, chock the wheels not being worked on, jack up the vehicle and ensure its stability.
We recommend you start replacing the pads on one side of the axle at a time.
The second brake may serve as a guide for the correct positioning of the individual parts during reassembly.
WARNING! Springs/clips holding down the pads may be under spring tension; relieve in a controlled fashion and keep in place using the caliper body.Do not operate the brake once the pads have been removed.
WARNING! If inappropriately handled, brake fluid may cause serious injury or damage. Observe the brake fluid manufacturer’s instructions.
CAUTION! To re-position the brake pads correctly, repeatedly operate the brake once the vehicle is back on the ground.
Repeat this process until the brake pedal travel has stabilised at approx. one-third of its total travel. At a constant maximum pedal force, the pedal travel must not change even over a prolonged period of application.CAUTION! If the pressure point and consistency cannot be achieved, recheck the entire braking system, as otherwise the risk of a brake failure cannot be ruled out.
Recheck the braking system for leaks.
This Brembo product has been designed to comply with all applicable safety standards. Products are not intended to be used differently from the specific use for which they have been designed and manufactured. Use for any other purpose, or any modification to or tampering with the Product can affect the performance of the Product and may render the Product unsafe.
Such modification or improper use will void the Limited Warranty, and may subject the individual so using the Product to liability for bodily injury or property damage to others
Brake pads are subject to wear and must therefore be checked at regular intervals.
If the thickness of friction material remaining on a pad is less than 2 mm or the wear indicator lights up, replace all the pads on an axle.
Brembo EV KIT discs and Brembo EV Kit pads must always be fitted in combination with one another. Combining them with different products could jeopardise the proper functioning of the KIT.
In these instructions, the “DANGER!” warning means procedures which, if not observed, have a high degree of probability that they will cause serious injury or even death. “CAUTION”” means procedures which, if not observed, could result in physical damage whereas “WARNING!” means procedures which, if not observed, could possibly cause damage to the vehicle.
Before commencing replacement, ascertain that the spare parts are suitable for the make and model of the vehicle. This Product is vital to the safe operation of the vehicle on which it is installed, and it is intended to be installed only by a skilled, qualified individual who has been trained and/or is experienced in the installation and use for which the Product is intended.
The installer must be equipped with the proper tools of his trade, and with the knowledge and experience to deal with vehicle repairs. Improper or incorrect installation, whether caused by a failure to follow these Instructions faithfully and completely or otherwise, will void the Limited Warranty and could subject the installer to liability in the event of personal injury or property damage.
Brembo shall not be liable for any damage or injury caused to or by any person operating a vehicle on which a replacement product has been improperly installed.
Replaced parts must be disposed of in accordance with the law.It is vital to avoid sharply striking and/or damaging the Product, its parts and its components, as this can impair their efficiency and may cause them to malfunction. If necessary, replace any damaged part or component. To avoid injury we recommend the following: